Paper Size

Select from the list of paper size . The paper sizes will adapt to the Units specified.

 

Units

Select the drawing sheet units from the list (mic, mm, cm, m, mil, in, ft or yd). The default unit is highlighted.

 

Scale

Enter the drawing sheet Scale (e.g., 1/1, 1/2, etc.)..

 

The drawing sheet scale factor is ignored completely within a layout view, and the individual layout view's scale sets the scale factor. The drawing sheet scale value only applies to geometry that has been added to the drawing sheet directly, and doesn't belong to any layout view.

 

Grid Spacing

Sets the snap grid spacing.

 

Enable "Smart Pick"

When checked, cursor movement will automatically detect and highlight fixed and relational pick points. This is referred to as "Smart Pick."

 

 

 

• OK - Pick OK to accept the new settings.

• Reset - Pick Reset to restore the previous settings.

• Cancel - Pick Cancel to close the form without saving any changes.